| |
Features
• Will lash any single or multiple overhead
cables up to 76 mm (3 in.) diameter across
on any suspension strand from 6 mm (1/4 in.) to 11 mm (7/16 in.). A factory
modification will allow the lasher to
accommodate 13 mm (.535 in.) strand if
necessary.
• Each of two recessed magazines will hold a
365 m of 1 mm wire
(1200 ft coil of .045 in.)
lashing wire or 140 m of 1.6 mm (450 ft. of .065 in.). The
Lashing Wire is fully recessed and covered
by a gate.
• J2 Lashers make overlashing easy. Just
push down on the strand lock, rotate it a
quarter turn to disengage and you can
overlash additional cables together on
previously lashed cable.
• Positive internal gear-to-gear mechanism
has no chains or belts to stretch, slip or
break.
• Pre-drilled and tapped at the factory for
mounting of the lasher guard or “halo”. For
use when lashing in overgrown areas..
• The lasher is furnished with a rugged
lightweight storage chest with corrosion
resistant hardware, recessed latches and a
moisture-proof, tongue-ingroove for
maximum protection when not in use.
• Supplied with a 1.8 m bridle rope assembly
and snap hooks, and an information and
operation manual.
|
|
Ordering details |
| Product No |
|
Description |
G-GMP-86070 |
|
J2 Cable Lasher c/w Case
for 1 mm (.045") Dia. Wire |
G-GMP-86071 |
|
J2 Cable Lasher c/w Case,
modified for 140 m (450ft)
(optional) for 1.6 mm (.065") Dia. Wire |
G-GMP-86072 |
|
J2 Cable Lasher Modified
for 14 mm (.535”) Strand |
G-GMP-86074 |
|
J2 Cable Lasher w/o Strand
Lock |
G-GMP-03165 |
|
Bridle Rope Assy only |
G-GMP-08189 |
|
Case Only |
G-GMP-70190 |
|
Towing Lanyard 10.7m
(Optional) |
G-GMP-70012 |
|
Lasher ‘Halo’ Guard
(Optional) |
G-GMP-71530
thru
G-GMP-71530
|
|
Lashing Wire |
J2 Operations and Maintenance Manual
Lasher guard assembly instructions

|